Maintenance - Husqvarna P 524XR EFI Operator's Manual

State of charge
Battery charge level, 5 levels.
0-25%
25-50%
50-75%
75-100%
Remote control
For instructions for the remote control, refer to
control on page 69 .
Introduction
WARNING:
safety chapter before you do maintenance
on the product.
Daily maintenance before use
Make sure that nuts and screws are tightened.
Make sure that there are no fuel or oil leaks.
Clean the product.
Clean the inner surfaces of the cutting deck.
Clean the engine and the muffler.
Make sure that the cold air intake of the engine is not blocked.
Make sure that the safety devices are not defective.
Examine the blades in the cutting deck.
Examine the cutting deck for damages.
Examine and do a test of the brakes.
Do a check of the engine oil level.
Do a check of the transmission oil level.
Make sure that the high beam light and the work light operate correctly.
X = The instructions are given in this operator's manual.
O = The instructions are not given in this operator's manual. Let an approved service agent do the maintenance.
1929 - 003 - 05.12.2023
Symbol

Maintenance

Remote
Read and understand the
State of charge
Battery error.
• Press the Browse button (A) to move to the next
symbol in the display.
• Press the Selection button (B) to make a selection.
Note:
The Information center display changes mode
if the buttons are pushed at the same time. Refer to
Troubleshooting for the remote control on page 74 .
Maintenance schedule
Symbol
43