Husqvarna P 524XR EFI Operator's Manual page 61

CAUTION:
cause unwanted noise. Use only the
blades given in
82 .
7. Install the washer and the bolt to attach the blade.
Tighten the bolt with the correct torque. Refer to
Technical data on page 82 .
To do a check of the engine oil level
1. Park the product on level ground and stop the
engine.
2. Remove the engine cover.
3. Loosen the dipstick and pull it out.
4. Clean the oil from the dipstick.
5. Put the dipstick back in. Do not tighten it.
6. Pull the dipstick out and read the oil level.
7. The oil level must be between the marks on the
dipstick. If the level is near the ADD mark, fill oil to
the FULL mark.
8. Fill the oil slowly through the hole for the dipstick.
Use an oil with viscosity that agrees with the
temperature ranges in the figure.
-20°C -10°C 0°C
SAE5W-20
-4°F -14°F 32°F
1929 - 003 - 05.12.2023
Incorrect blade type can
Technical data on page
10°C 20°C 30°C 40°C
SAE40
SAE30
SAE20W-50
SAE10W-40
SAE10W-30
50°F 68°F 86°F 104°F
CAUTION:
types of oil.
9. Tighten the dipstick correctly before you start the
engine. Start and idle the engine for approximately
30 seconds. Stop the engine. Wait 30 seconds and
do a check of the oil level again.
To replace the engine oil and the oil
filter
If the engine is cold, start the engine for 1–2 minutes
before you drain the engine oil. This makes the engine
oil warm and easier to drain.
WARNING:
for more than 1–2 minutes before you drain
the engine oil. The engine oil becomes very
hot and can cause burn injuries. Let the
engine become cool before you drain the
engine oil.
WARNING:
your body, clean with soap and water.
1. Remove the engine cover.
2. Put a container below the oil drain plug.
3. Remove the dipstick.
4. Remove the oil drain plug from the engine.
5. Let the oil run out into the container.
6. Attach the oil drain plug and tighten it fully.
Do not mix different
Do not operate the engine
If you spill engine oil on
61