Husqvarna P 524XR EFI Operator's Manual page 50

Fuse overview
2 4 6 8
1 3 5 7
1. 12 V power to the mower control module, 20 A
2. Display power, 5A
3. Ignition power, 5 A
4. J14 + 12 V, warning light, 10 A
5. J16 + 12 V, Extra switch, Extra out, Hydraulic
power,10 A
6. Parking brake / Seat, 10 A
7. Light power, 10 A
8. USB, 12 V outlet, 12 V switch power, 10 A
9. 12 V memory power to the mower control module, 3
A
10. 12 V, Fuse for electric actuator deck lift, 30 A
11. Fuse indication lamp
12. Mower control module AUX, 15 A
13. +12 V Battery, 10 A
To replace a fuse
A broken fuse is identified by a burned fuse wire. For
fuse 1-8, 12 and 13, the fuse indication lamp will go off if
a fuse is broken.
The location of the fuses can be found in the fuse
Fuse overview on page 50 .
overview, refer to
1. Find the broken fuse:
a) Remove the right side cover to replace fuses 1–
8.
50
12
13
11
9
b) Open the engine cover to replace the fuses 9
and 10.
2. Pull the fuse from the holder.
3. Replace the broken fuse with a new fuse of the
same type.
4. Install the covers.
Note:
If the main fuse breaks again a short period
after you replace it, there is a short circuit. Repair the
short circuit before you operate the product again. Let
an approved service agent help you.
To charge the battery
• Charge the battery if it is too weak to start the
engine.
• Use a standard battery charger.
CAUTION:
charger or start booster. That will cause
damage to the electrical system of the
product.
• Always disconnect the charger before starting the
engine.
To do an emergency start of the engine
If the battery is too weak to start the engine, you can use
jumper cables to do an emergency start. This product
10
Do not use a boost
1929 - 003 - 05.12.2023