Husqvarna P 524XR EFI Operator's Manual page 19

on or examine the engine or the cutting deck
without these conditions:
• The engine is off.
• The product is parked on a level surface.
• The parking brake is applied.
• The ignition key is removed.
• The cutting deck is disengaged.
• The ignition cables are removed from the
spark plugs.
• The remote control is set to off.
WARNING:
the engine contain carbon monoxide, an
odourless, poisonous and very dangerous
gas. Do not operate the product in closed
spaces or spaces with not sufficient air flow.
WARNING:
instructions that follow before you use the
product.
• For best performance and safety, do maintenance
on the product regularly as given in the maintenance
Maintenance schedule on page
schedule. Refer to
43 .
• Electrical shocks can cause injuries. Do not touch
the cables when the engine is on. Do not do a
function test on the ignition system with your fingers.
• Do not start the engine if the protective covers are
removed. There is a high risk of injury caused by
moving or hot parts.
• Let the product become cool before you do
maintenance near the engine.
• The blades are sharp and can cause cuts. Wind
protection around the blades or use protective
gloves when you do work on the blades.
• Always put the cutting deck in servicing position to
clean it. Do not park the product near the edge of a
ditch or slope to get access to the cutting deck.
CAUTION:
instructions that follow before you use the
product.
• Do not crank the engine if the spark plug or ignition
cable is removed.
• Make sure that all nuts and bolts are tightened
correctly and that the equipment is in good condition.
• Do not change the adjustment of governors. If the
engine speed is too high, the product components
can become damaged. Refer to
page 82 for highest permitted engine speed.
• The product is approved only with the equipment
supplied or recommended by the manufacturer.
1929 - 003 - 05.12.2023
The exhaust fumes from
Read the warning
Read the caution
Technical data on
WARNING:
hoses. Pressurized hydraulic fluid can
escape and cause damage to your skin.
Remote control safety
Before you operate the product with the remote control,
read and understand the safety chapter for P 524XR
Safety on page 13 .
EFI, refer to
Safety definitions
Warnings, cautions and notes are used to point out
specially important parts of the manual.
WARNING:
injury or death for the operator or bystanders
if the instructions in the manual are not
obeyed.
CAUTION:
damage to the product, other materials or
the adjacent area if the instructions in the
manual are not obeyed.
Note:
Used to give more information that is necessary
in a given situation.
General safety instructions
WARNING:
instructions that follow before you use the
product.
• Read and understand the operator's manual and the
instructions for the remote control carefully before
you start the product. Do not let a person operate
the product with the remote control unless they have
read and understand the contents of the operator's
manual.
• Always be careful and use your common sense. Do
not enter situations where you feel uncertainty. If
you feel uncertainty about the operating procedures
after you read the operator's manual, speak to your
Husqvarna servicing dealer before you continue.
• Save all warnings and instructions and make sure
that they are available to all operators.
• The remote control will automatically be put to off if
falls or hits the ground. If the product stops suddenly,
it can cause a dangerous situation.
• Charge the remote control battery before you
operate the product in remote control mode. The
remote control is automatically set to off if the battery
voltage is too low. If the product stops suddenly, it
can cause a dangerous situation.
• Charge or replace the battery when the information
center display indicates low battery of the remote
Information center display on page
control. Refer to
Do not touch the hydraulic
Used if there is a risk of
Used if there is a risk of
Read the warning
19