Husqvarna P 524XR EFI Operator's Manual page 45

Maintenance
Examine and adjust valve clearance of the engine.
Clean the surface of the lap valve seating.
Examine the muffler and heat deflector.
Replace the engine oil.
Replace the engine oil filter.
Replace the spark plug.
Replace the fuel hoses.
Do a check of/adjust front and rear wheel speed.
Do a check of the oil level in the transmission.
Replace the oil in the transmission.
Make sure that the tire pressure is correct.
Examine and adjust the cutting height settings.
Replace the belt of the cutting deck.
Examine the cutting deck for damages.
Examine the blades in the cutting deck.
To clean the product
CAUTION:
washer or a steam cleaner. Water can go
into bearings and electrical connections and
cause corrosion which causes damage to
the product.
Clean the product immediately after use.
• Do not clean hot surfaces such as the engine,
muffler and exhaust system. Wait until the surfaces
are cool, then remove the grass or dirt.
• Before you clean with water, clean with a brush.
Remove grass cuttings and dirt on and around the
transmission, the transmission air intake, and the
engine.
• Use running water from a hose to clean the product.
Do not use high pressure.
• Do not point the water at electrical components or
bearings. Detergent usually increases the damage.
• To clean the cutting deck, put it in the servicing
position and hose it down with water.
• When the product is clean, start the cutting deck for
a short period to blow off remaining water.
1929 - 003 - 05.12.2023
Do not use a high-pressure
Weekly (40 hour After the first 50
intervals)
X
Each 5 years
X
X
• Examine all lubrication points and lubricate if it is
necessary. Always lubricate the bearings after you
clean the product.
To clean the engine and the muffler
Keep the engine and muffler free from grass cuttings
and dirt. Grass cuttings soaked in fuel or oil on the
engine can increase the fire risk and the risk that the
engine becomes too hot. Let the engine cool before it is
cleaned. Clean with water and a brush.
Maintenance in-
terval in hours
hours
100 200
O
O
X
X X
X X
O
O
X
O
X
X
X
X
400
X
O
X
45