Husqvarna P 524XR EFI Operator's Manual page 40

2. Push the parking brake button to release the parking
brake.
Note:
The operation prevented indicator comes
on when the product is in a turn position when you
start the remote control mode and try to operate the
product with the remote control. Align the wheels
of the product and start again, refer to
remote control mode on page 37 .
3. Push the drive control to move the product forward.
Pull the control for the drive in your direction to move
the product rearward.
4. Push the steering control to the left or to the right to
control the direction of the product.
40
Note:
changes the direction of the wheels gradually. Small
movements of the controls make small movements
of the wheels. The controls go back to the neutral
positions when they are released.
5. Release the drive control to stop the movement of
the product.
Note:
product will stop in less than 1.5 seconds.
Note:
the following on the remote control:
• Push the engine stop/start switch to the left.
• Push the ON/OFF button.
• Push the machine stop button.
To start the
The movement of the steering control
When the drive control has been released, the
The product will automatically stop when you do
WARNING:
Be careful when you push
the machine stop button in a slope. The
angle of the slope can cause unwanted
movement down the slope.
WARNING:
Be careful when you
operate the product near an obstacle, wall or
slope. The product has articulated steering,
the rear end of the product moves in the
opposite angle from the front end.
CAUTION:
Move the controls carefully.
To move the controls with force does not
make the performance of the product better.
The controls can become damaged if you
operate them with too much force.
CAUTION:
Do not lift the remote control
by the controls.
1929 - 003 - 05.12.2023