Table of Contents
Advertisement
•
Move the product forward at low speed if the grass is
high and thick.
•
Use full throttle when you cut the grass.
•
Cut the grass in an irregular pattern.
•
Use the left side of the cutting deck when you
cut near trees, bushes or paths. The blade cuts
approximately 15 mm in from the side of the cutting
deck.
•
When you cut large areas, move the product to the
right during 1 or 2 turns around the work area. This
procedure will keep the grass discharge away from
shrubs, fences and driveways. After approximately
2 turns around the work area, cut in the opposite
direction.
Introduction
WARNING:
maintenance work you must read and
understand the safety chapter.
Maintenance schedule
General
Clean the battery and the terminals.
Do a check of the battery level. Charge the battery
if it is necessary.
Examine all belts and pulleys for wear and damage.
Replace worn or damaged parts.
Clean the engine and the transmission.
Examine all wires for damage.
Lubricate the product. Refer to the lubrication over-
view.
Make sure that all fasteners are tightened correctly.
Make sure that the tire pressure is correct in all
tires.
2117 - 003 - 16.01.2024
Maintenance
Before you do any
•
To get the best cutting result, cut the grass
frequently.
Maintenance schedule
X = The instructions are given in this operator's manual.
O = The instructions are not given in this operator's
manual. Let an approved service agent do the
maintenance.
Before each use/
weekly
Every 50 h or an-
nually
O
X
O
X
X
O
X
O
X
X
19
Advertisement
Chapters
Table of Contents
