Husqvarna P 524XR EFI Operator's Manual page 76

Problem
The information center dis-
play shows the symbol that
follows.
2.
The information center dis-
play shows the symbol that
follows.
Other errors.
Panel - Troubleshooting for the remote control
If you cannot find a solution to your problems in this
manual, speak to your Husqvarna servicing dealer.
Symbol
76
Cause
The pairing operation between the remote
control and the receiver has been started.
The remote control is locked and cannot
connect to the remote control receiver.
If other errors occur, put the remote control to OFF and stop the product. Restart the
product and the remote control after 5 seconds. Speak to your Husqvarna servicing
dealer if the problem continues.
Cause
Operation prevented indicator.
OPC indicator.
General error.
Engine oil pressure sensor.
Solution
Restart the remote control to stop the
pairing operation.
Speak to your Husqvarna servicing
dealer if a new pairing operation is nec-
essary.
Push and hold the right button on the
information center display while you
push the left button 3 times. Refer to
Information center display on page 42 .
Shows on the remote con-
trol panel
The symbol is red.
The symbol is red.
The symbol is red.
The symbol is red.
Cause/Action
The machine stop is engag-
ed.
The product is in a turn po-
sition when you start the re-
mote control mode and try
to operate the product with
the remote control. Align the
wheels of the product and
To start
start again, refer to
the remote control mode on
page 37 .
The seat switch is engaged
when you start the engine.
Operator presence
Refer to
control (OPC) on page 16 .
A system error has occur-
Troubleshoot-
red. Refer to
ing for the remote control
on page 74 and Error codes
and descriptions on page
77 .
Low oil pressure. Refer to
To do a check of the engine
oil level on page 61 .
1929 - 003 - 05.12.2023