Husqvarna P 524XR EFI Operator's Manual page 35

Rear transmission
• To open the bypass valve, open the locknut (A) ¼–½
turn counterclockwise and then the valve screw (B) 2
turns counterclockwise.
• To close the bypass valve, close the valve screw (B)
and tighten to 8 Nm and then tighten the locknut (A)
to 30 Nm.
Front transmission
• To open the bypass valve, open the locknut (A) ¼–½
turn counterclockwise and then the valve screw (B) 2
turns counterclockwise.
A
B
• To close the bypass valve, close the valve screw (B)
and tighten to 8 Nm and then tighten the locknut (A)
to 30 Nm.
Remote control
For instructions for manual operation of P 524XR EFI,
Operation on page 29 .
refer to
The remote control has all controls that are necessary to
operate the product. The controls on the remote control
respond directly when you operate them.
The remote control operates by radio signal
transmission. If there is an interference in the
transmission, the frequency changes automatically.
CAUTION:
that comes with the product.
A pairing operation between the product and the remote
control is done by the factory. If is necessary to do
a new pairing operation between the product and the
remote control, speak to your Husqvarna servicing
dealer.
1929 - 003 - 05.12.2023
A
B
Use only the remote control
To do before you operate the product with the
remote control
WARNING:
see the product at all times when you
operate it with the remote control. The
receiver for the remote control signal
enables operation when the product is
temporary hidden behind an obstacle.
WARNING:
distance when you operate the product with
the remote control. When the product is out
of operation range of the remote control, the
parking brake is automatically applied, the
drive of the cutting deck is disengaged and
the engine stops. This can cause dangerous
situations for you or others. For information
related to operation range, refer to
data on page 82 .
Correct operation distance
During operation with cutting
deck engaged.
During operation with cutting
deck disengaged.
• Make sure that there are no persons in the work
area.
• Read the operator's manual carefully and make sure
that you understand the instructions.
• Learn how to operate the product with the remote
To learn how to operate the product
control. Refer to
in remote control mode on page 36 .
• Do daily maintenance on the product and the remote
Maintenance schedule on page 43
control. Refer to
Remote control on page 69 .
and
• Make sure that the remote control is not damaged
and that all controls and switches are in neutral
position.
Make sure that you can
Stay in correct operation
Technical
Operator Bystand-
ers
15-50 m >50 m
5-50 m >50 m
5m
15m
50m
35