Husqvarna P 524XR EFI Operator's Manual page 22

WARNING:
a slope, apply the parking brake and
stop the engine to prevent the product
from falling.
Note:
If the remote control is set to off, the
parking brake is automatically applied, the drive of
the cutting deck is disengaged and the engine stops.
WARNING:
a slope, always enter the work area from
above. Do not stay below the product.
• Make sure that you are in a safe and stable position
during operation. Do not walk or stay above or below
the product.
• When you operate the product in remote control
mode, the maximum possible slope angle is
increased. The maximum possible slope angle
changes in different weather, ground conditions and
cutting method. Refer to
82 .
22
If the product stops on
If the product stops on
Technical data on page
WARNING:
slope angles are measured with
Husqvarna original parts. Do not
make modifications to the product.
Modifications that are not approved by
the manufacturer can cause serious
injury or death.
WARNING:
product on ground that slopes more than
10° in manual mode.
Note:
Attachments on the product can decrease
the maximum permitted slope angle. Only use
attachments on the product that are approved for
operation with the remote control. Refer to
data on page 82 .
• Do not operate the product with the remote control
on ground that slopes more than 20° on slippery
surfaces.
WARNING:
cause the product to decrease traction
and slide or fall. Slippery surfaces can
cause the operator or bystanders to slide
or fall.
WARNING:
the ground conditions and calculate the
risk of slippery surfaces or not stable
ground. Slippery surfaces can cause the
product to slide or fall on a slope with an
angle less than the maximum possible
slope angle.
• Before you make a decision on which cutting method
to use, examine the work area and prepare your
work and where to turn.
• Put the cutting deck height to position 6 if you feel
uncertainty of the ground conditions. Refer to
adjust the cutting height (C112, C122, R137) on
page 32 or To adjust the cutting height (C112X,
C122X, R137X) on page 33 .
• Push the throttle control on the product to full
throttle position when you operate the product on
slopes. The performance of the product changes
with different engine speed.
Note:
Push and hold the boost button on the
remote control. The boost function of the remote
control increases the transmission power of the
product, which increases slope, to move the product
out of an obstacle or hole, or to move the product
between areas that you do not cut.
The maximum possible
Do not operate the
Technical
Slippery surfaces can
Always do a check of
To
1929 - 003 - 05.12.2023