Resetting Using The Front Or Rear Panel Reset Button - Extron electronics DXP HD 4K PLUS Series User Manual

To reset the switcher to the factory default settings (see figure 32):
1. Disconnect power from the DXP, then immediately reconnect it. All front panel LEDs
blink four times, then turn off, leaving the I/O LEDs lit red.
2. Immediately press and continue to hold the I/O button while the front panel LEDs do
the following:
a. The Input Signal and HDCP LEDs blink in order in a clockwise, circling pattern.
b. All front panel LEDs blink three times, then turn off.
c. The I/O Video LED lights green.
Disconnect and reconnect power to the
All front panel LEDs blink four times, then
turn off. The Video and Audio LEDs light red.
Press and hold the I/O button and continue to
hold it until only the I/O Video LED is lit green.
Release the I/O button.
Figure 32.
3. When only the Video LED is lit steadily green, release the I/O button.

Resetting Using the Front or Rear Panel Reset Button

The recessed Reset button (see
initiates various levels of soft resets, which restore various tiers of switcher settings to their
defaults. For different reset levels, press and hold the button while the switcher is running
or press and hold the button while you apply power to the switcher. Use a pointed stylus,
ballpoint pen, or small screwdriver to press the button. The
summary of the reset modes.
ATTENTION:
Review the reset modes in the
•
reset mode could result in unintended loss of flash memory programming, port
reassignment, or a switcher reboot.
Analysez minutieusement les différents modes de réinitialisation voir
•
suivante. Appliquer le mauvais mode de réinitialisation peut causer une perte
inattendue de la programmation de la mémoire flash, une reconfiguration des ports
ou une réinitialisation du sélecteur.
Power
I/O
I/O
System Reset via Front Panel Buttons
figure 3,
D
table on the next page
VIDEO
AUDIO
VIDEO
AUDIO
, on page 7, or figure 9,
J
table on the next page provides a
carefully. Using the wrong
DXP HD 4K PLUS Series • Operation
, on page 16) that
tableau page
33