Routine maintenance
Adjusting for paper curl
Measuring the paper curl
5-42
b. Lower the left and right black levers to the horizontal
position, as shown in figure 5-44.
Figure 5-44. Lowering the levers
7. Close the processor door.
Each sheet of paper has a natural curve called the curl. Storing
or using the paper under humid conditions may increase the curl.
When too much curl causes paper handling problems, adjust the
decurler in the processor. The decurler flattens the paper after
fusing.
1. Program and print five 1-sided, 8.5 x 11 inch (216 x 279 mm)
sheets to the top tray.
NOTE: Keep the image toward you, as shown in figure 5-45.
2. Measure the amount of curl in the prints by holding the five
prints in the top center of the short edge.
DocuTech 61xx Operator Guide