Replacing The Dry Ink Waste Container - Xerox DocuTech 6100 Operator's Manual

Replacing the dry ink waste container

DocuTech 61xx Operator Guide
NOTE: If any dry ink should get on your skin, wash with mild
soap and cold water.
When directed by a screen message, replace the dry ink waste
container. If the dry ink waste container is not replaced, the
printer will eventually stop, and it will not operate until the dry ink
waste container is replaced.
Do not tip the waste container.
Do not use warm or hot water, or general cleaning solvents to
remove dry ink from your skin or clothing. The heat or solvent
will set the dry ink and make it difficult to remove. If any dry ink
should get on your skin, wash with mild soap and cold water.
If any dry ink should get on your clothes, brushing with a dry
paper towel or a stiff-bristled brush may remove the ink. If not,
launder your clothes with detergent and cold water. Tell a
commercial dry cleaner that the spot is dry ink or "toner" so that
they will not use a solvent that will set the dry ink stain.
1. Open the processor doors and locate the dry ink waste
container.
2. Place a drop cloth on the floor under the dry ink waste
container area.
3. Remove the full waste container from the system.
a. Grasp the tab on the dry ink waste container and pull the
container out slowly, as shown in figure 5-14.
Routine maintenance
CAUTION
CAUTION
5-17