Xerox DocuTech 6100 Operator's Manual page 44

Routine maintenance
5-2
Figure 5-1. Preparing the paper tray
NOTE: To load the paper correctly, refer to the label located
on the inside panel at the front of the paper tray. Remove any
damaged sheets from the top of the stack.
Do not load the paper above the red line. A jam could occur if too
much paper is loaded in the tray.
6. Load the required paper into the paper tray. Load paper with
the curl side facing down. Load Xerox paper with the package
wrapper seam side facing up.
NOTE: When loading drilled paper, be sure to fan the edge
where the holes are located.
7. Position the stack against the front right corner of the tray, as
shown in figure 5-2. This is indicated by the green arrow on
the bottom of the tray.
CAUTION
DocuTech 61xx Operator Guide