Adding Fuser Agent - Xerox DocuTech 6100 Operator's Manual
Xerox docutech 6100: operator guide
Hide thumbs
Also See for DocuTech 6100:
- Install manual (60 pages) ,
- Planning manual (16 pages) ,
- Release note (2 pages)
Table of Contents
Advertisement
Routine maintenance
Adding fuser agent
5-20
When directed by a message, add fuser agent as soon as
possible. If fuser agent is not added, the printer will stop after
approximately 5,000 prints. It will not run until fuser agent is
added.
The fuser area can reach temperatures of approximately
425°F (218°C). Exercise care to prevent burns when
working in this area.
Fuser lubricant for other printers may not be compatible. Order
and use fuser agent only for the printer.
1. Open the processor doors.
2. Place a drop cloth on the floor under the fuser area.
3. Open the fuser drawer.
a. Locate the fuser drawer.
b. Grasp the green handle on the fuser drawer and pull it out
until it stops.
WARNING
CAUTION
DocuTech 61xx Operator Guide
Advertisement
Table of Contents
