Stock Satisfaction Guides - Xerox DocuTech 6100 Operator's Manual

Technical information

Stock satisfaction guides

Table 7-5. Satisfaction guide for paper trays 1 and 2
Reliable feeds may be
Stock expected
Size 8 x 10 inches to 9 x 14
inches (203 x 254 mm to
229 x 356 mm)
Weight Substance 20 to 110 (75 to
200 g/m2)
Capacity Tray 1 - 1100 sheets,
substance 20 (75 g/m2)
Tray 2 - 600 sheets,
substance 20 (75 g/m2)
Type or Xerographic bond paper in
condition good condition
Drilled stock, fanned
thoroughly
Tab stock in perfectly flat
condition
Table 7-6. Satisfaction guide for paper tray 3
Reliable feeds may be
Stock expected
Size 8 x 10 inches to 17 x 11
inches (203 x 254 mm to
432 x 279 mm)
7-8
Less reliable feeds may be
expected
Substance 16 to 19 (60 to 72
g/m2)
Slightly curled paper
Intermixed weights
Transparencies
Label stock
Adhesive drafting film
Paper with reinforced edges
Less reliable feeds may be
expected
Suggested alternatives
Stock smaller than 8 x 10
inches cannot be used.
For stock larger than 9 x 14
inches (229 x 356 mm), refer
to the tray 3 satisfaction
guide.
Weights outside the limits
shown are not
recommended.
Substance 110 (200 g/m2)
must be long grain. Do not
use short grain.
For greater capacity, use
Tray 3.
Do not use excessively
curled paper
Substance 110 (200 g/m2)
must be long grain. Do not
use short grain.
Use transparencies with a
white stripe.
Freshly printed offset prints,
use tray 3.
Refer to the "Using various
stocks" section for any stock
not defined in this guide.
Suggested alternatives
Smaller or larger sizes
cannot be used.
DocuTech 61xx Operator Guide