Infoprint Manager Procedures For Windows Nt And Windows 2000 - Xerox DocuPrint 100 Installation Planning Manual
Xerox docuprint 100: install guide
Hide thumbs
Also See for DocuPrint 100:
- Software manual (498 pages) ,
- Service manual (304 pages) ,
- Operator's manual (234 pages)
Table of Contents
Advertisement
Defining the channel-attached printer to the host
Infoprint Manager procedures for Windows NT and Windows 2000
E-4
This section explains how to access the Create Printer Wizard in
the Infoprint Manager Administration GUI, which allows you to
create an actual destination (physical printer) using Infoprint
Manager for Windows NT and Windows 2000.
To create a channel-attached printer:
1. On the menu bar, click Printer, then Create, then PSF, then
Channel.
NOTE: The Channel is not shown in the menu by default. To
add it, select Printer, then Add/Remove Menu Items.
2. Provide information as prompted by the wizard. For
assistance, refer to the Infoprint Manager Administration GUI
online help.
NOTE: From the Model pulldown menu, make sure to select
Infoprint 60 as your printer model.
3. If you did not enable the printer with the Create Printer
Wizard, use the Infoprint Manager Administration GUI to
enable it.
For detailed information on the attribute default values set by the
wizard, refer to IBM Infoprint Manager for Windows NT and
Windows 2000, Getting Started.
Installation Planning Guide
Advertisement
Table of Contents
