Printer Hardware Specifications And Requirements Summary - Xerox DocuPrint 100 Installation Planning Manual

Printer specifications and requirements

Printer hardware specifications and requirements summary

6-28
Table 6-10. Turning radius for inverter feeder/stacker module (Continued)
Passage or doorway A width
38 inches / 96.5 cm
39 inches / 99.1 cm
40 inches / 101.6 cm
41 inches / 104.1 cm
42 inches / 106.7 cm
43 inches / 109.2 cm
NOTE: These turning figures are based on inverter/feeder/
stacker dimensions of 28 inches / 711 mm by 42 inches / 1,067
mm.
The following table lists the turning requirements for the feeder/
stacker module.
Table 6-11. Turning radius for feeder/stacker module
Passage or doorway A width
29 inches / 73.7 cm
30 inches / 76.2 cm
31 inches / 78.7 cm
32 inches / 81.3 cm
33 inches / 83.8 cm
NOTE: These turning figures are based on inverter/feeder/
stacker dimensions of 28 inches / 71.1 cm by 32.25 inches / 81.9
cm.
The following table summarizes the specifications and electrical
requirements of your printer hardware components.
For a summary of controller hardware specifications and
requirements, refer to the "Controller specifications and
requirements" chapter of this guide. Contact your service
representative if you have questions not specifically addressed in
this guide.
Minimum passage B width
32 inches / 81.3 cm
31 inches / 78.7 cm
31 inches / 78.7 cm
30 inches / 76.2 cm
29 inches / 73.7 cm
29 inches / 73.7 cm
Minimum passage B width
33 inches / 83.8 cm
32 inches / 81.3 cm
31 inches / 78.7 cm
30 inches / 76.2 cm
29 inches / 73.7 cm
Installation Planning Guide