Denon AVR-1602 Operating Instructions Manual page 27

[_[e]]![.l][
[2] Listening over headphones
Connect the headphones to the
PHONES iack of the front panel.
Press the SPEAKER A or B button turn SpEWeR
o o
the speaker off
A B
NOTE:
To prevent hearing loss, do not raise the volume level excessively
when using headphones
° _ o o o o o o o o o o o
2
'_ Caution: No sound is produced from the headphones when
speakers A or B are turned on.
[3] Turning the sound off temporarily (muting)
1
Use this to turn off the audio output
temporarly
Press the MUTING button
Canceling MUTING mode
Press the MUTING button again
Muting w/I also be canceled when
MASTER VOL is adjusted up or
down.
MUTING
£.q II
[4] Combining the currently playing sound with the desired image
1
Simulcast playback
Use this switch to monitor a _DEOSELECT
video source other than the
-%
audio source
Press the VIDEO SELECT
button repeatedly until the
(Main u/it) (Remote contro unit}
desired source appears on
the display
"_ Canceling simulcast playback•
• Select "SOURCE" using the video select button
• Switch the program source to the component connected to
the video input
'I
]oXol ....
1
==B==
[5] Checking the currently playing program source, etc.
1
Front panel display
• Descriptions of the unit's
operations are also
displayed on the front
panel display In addition,
the display can be
switched to check the
unit's operating status
while playing a source by
pressing the STATUS
button
_ATUS
(Main u/it) (Remote contro unit}
,,
II
o o o o
1
2 1
2
Using the dimmer function
• Use this to change the brightness of the D,MMER
display.
The display brightness changes in four
steps (bright, medium, dim and off) by "-_
pressing the main unit's DIMMER button (Manullit}
repeatedly•
The brightness changes in 3 steps each time the button is
pressed, and finally the display turns off
27