Denon AVR-1602 Operating Instructions Manual page 17

[_Et]_[:]I
1
2
ON / STANDBy
Check that all the components are correct, then press the POWER operation switch on the main unit or
the POWER button on the remote control unit to turn on the power
AVR/AVC
(Mail unt) (Remote co/tlol unt)
Press the SYSTEM button to enter the setting
:+::iii;'.,.':iii; TEH :iii; ET UF::']
NOTE: Please make sure the "AUDIO" position of the slide switch on the remote control unit.
Press the SELECT or C_ (down) button to switch to the speaker configuration set up
NOTE:
Press the SYSTEM button again to finish system set up System set up can be finished at any time. The changes to the settings made up to
that point are entered.
1
Use the _ (left) and _ (right) buttons to select your front speaker type.
(Initial)
:i. F::F;X::Ei".iT L...i:::iF;Xiiiii _
(left) button (right) button
Press the SELECT or O[] (down) button to switch to the center speaker setting
2
Use the C_ (left) and _ (right) buttons to select your center speaker type.
(Initial)
I II I_
2 Ciiii>.rTiii:i::i: SMnLi
(left) button (right) button
Press the SELECT or CD (down) button to switch to the surround speaker setting.
NOTE:
• When "Small" has been selected for the front speakers, "Large" cannot be selected for the center speaker
Use the _ (left) and {:]E) (right) buttons to select your surround speaker type.
(Initial)
(left) button (right) button
Press the SELECT or C_ (down) button to switch to the subwoofer setting.
17