Denon AVR-1602 Operating Instructions Manual page 26

_e]l![.t]][
Select the play mode.
Press the SURROUND MODE button, then press the SELECT
button.
SURROUND _ ___ SURROUND MODE
(Man unit} (Remote control unt)
To select the surround mode while adjusting suaPauNO
the surround parameters, channel volume or MODE
tone control, press the surround mode
button then operate the selector.
(See page 29) (Mail unt)
Start playback on the selected component.
• For operating instructions, refer to the component's
manual.
Adjust the volume.
Input mode display
• In the AUTO mode
One of these lights, dependi/g on the
input signal
O
• In the DIGITAL PCM mode
r_PUT
AUTO P_4
O /i \
• In the DIGITAL DTS mode
.... ,_T
o o
• In the ANALOG mode
.... _ST
o o
_S_ER VOlUblE C_
Tie volume leve is {Ma[fl u/it) (Remote cont ol unt)
d sphyed on the
master volume leve
d splay
The volume can be adjusted within the range of -60 to 0 to 18 dB,
in steps of 1 dB. However, when the channel level is set as
described on page 29, if the volume for any channel is set at +1 dB
or greater, the volume cannot be adjusted up to I8 dB (In this case
the maximum volume adjustment range is "18 dB -- (Maximum
value of channel level)".)
Input mode when playing DTS sources
• Noise will be output if DTS-compatible CDs or LDs are played in the
"ANALOG" or "PCM" mode
When playing DTS-compatible sources, be sure to connect the
source component to the digital input jacks (OPTICAL/COAXIAL)
and set the input mode to "DTS"
Input signal display
• DOLBY DIGITAL
o
• DTS
DIC'I'ALO _\
• PCM
_IO_TAL
O O
The _ indicator lights when digital signals are being input
properly If the _ indicator does not light, check whether
the digital input component setup (page 20) and connections are
correct and whether the component's power is turned on
NOTE:
• The _ indicator will light when playing
CD-ROMs
containing data other than audio signals, but no sound will be
heard.
[1] Adjusting the sound quality (tone)
The tone switches as follows each time the TONE CONTROL
button is pressed
TQNE
COt_rmO_
BASS _ TREBLE
(Main u/it)
With the name of the volume to be
adjusted selected, press the SELECT
button to adjust the level.
• To increase the bass or treble: Press
the SELECT UP button. (The bass or
treble sound can be increased to up
to +10 dB in steps of 2 dB.)
• To decrease the bass or treble: Press the SELECT DOWN
button (The bass or treble sound can be decreased to up
to -10 dB in steps of 2 dB)
If you do not want the bass and treble to be adjusted, turn on
the tone defeat mode
TOI*IE DEFEAT
The signals do not pass through the
bass and treble adjustment circuits,
providing higher quality sound
26