Akai MPC X User Manual page 480

AIR Solina
(continued)
Delay / Spring Reverb
Use this tab to adjust the settings for the delay and spring reverb
effects. Use the buttons on the right side to enable or disable each
effect.
Parameter
Delay Time
L/R Ratio
Feedback
LP Freq
Bell Freq
Bell Gain
Mix
Spring Reverb Pre-Delay
Time
Low Cut
Diffusion
Width
Mix
Description
Amount of time between the dry signal and the delayed
signal.
Reduces the delay Time in either the Left or Right stereo
field. This is useful for creating offset, panned delays.
Amount of signal fed back into the delay line.
Low pass frequency for feedback resonance.
Center frequency for feedback resonance.
Amount of gain applied to the resonant frequency.
Wet/dry amount of the delay effect.
Length of time between dry signal and reverberated
signal.
Length of reverb tail.
Center frequency for reverb signal low-cut filter.
Rate of increasing density of reverb reflections.
At lower settings, the sound of individual reflections is
more present.
At higher settings, reflections are more uniform.
Stereo width of reverb signal. Higher values give wider
stereo separation.
Wet/dry amount of the reverb effect.
Value Range
1/16 – 16/4
50:100 – 100:100 –
100:50
0–100%
100 – 16000 Hz
100 – 16000 Hz
0–100%
0–100%
0 – 250 ms
1.00 – 10.00 s
20 – 1000 Hz
0–100%
0–100%
0–100%
480