Akai MPC X User Manual page 465

Trans/Dist
Use this tab to adjust the settings for the Transient and Distortion effects.
Parameter
Transient Attack
Shape
Sustain
Distortion Pre-Shape
Drive
Threshold
High Cut
Mix
EQ/Comp
Use this tab to adjust the settings for the EQ and Compressor effects.
Parameter
EQ High Freq
High Gain
High Mid Freq
High Mid Q
High Mid Gain
Low Mid Freq
Low Mid Q
Low Mid Gain
Low Freq
Low Gain
Compressor Ratio
Attack
Threshold
Output
Description
Decreases or increases the amount of
transient attack applied to the signal.
Adjusts the shape of the processed transient. 0–100%
Percentage of sustain envelope subtracted
from or added to the transient effect.
Increases or decreases the high-end tone of
the incoming audio signal pre-distortion.
Amount of drive applied.
Signal level after which the distortion will be
applied.
Center frequency of the distortion signal high-
cut filter.
Wet/dry amount of the distortion effect.
Description
Center frequency for the High EQ band.
Amount of gain applied to the High EQ band.
Center frequency for the High Mid EQ band.
Width of the High Mid EQ band.
Amount of gain applied to the High Mid EQ
band.
Center frequency for the Low Mid EQ band.
Width of the Low Mid EQ band.
Amount of gain applied to the Low Mid EQ
band.
Center frequency for the Low EQ band.
Amount of gain applied to the Low EQ band.
Amount of compression applied.
Length of time to apply the compression.
Signal level after which the compressor will
be applied.
Amount of additional output gain for the
compressed signal.
Value Range
-100 – 0 – +100%
-100 – 0 – +100%
-100 – 0 – +100%
0–60 dB
-20.0–0.0 dB FS
1.00–20.0 kHz
0–100%
Value Range
1.20 – 20.0 kHz
Cut, -12.0 – 0 – +12.0 dB
120 Hz – 16.0 kHz
0.40–10.00
-18.0 – 0 – +18.0 dB
40.0 Hz – 8.00 kHz
0.40–10.00
-18.0 – 0 – +18.0 dB
20.0 Hz – 1.00 kHz
Cut, -12.0 – 0 – +12.0 dB
1.0:1 – 100.0:1
100 us – 300 ms
-60.0–0.0 dB
0.0–30.0 dB
465