Akai MPC X User Manual page 470

AIR Hype
(continued)
Effects 1
Use this tab to adjust the settings for the Low-Frequency Oscillator
and Modulation, Distortion and Hype effects.
Parameter
LFO Rate
Sync
Depth
Mod Rate
Adjust
Depth
Mix
Distortion Drive
Bias
Output
Mix
Hype Low
Lo-Mid
Hi-Mid
High
Description
Speed of the low frequency oscillator.
When Sync is set to 1st Note, Each Note, or Off: 0.03 – 30.00 Hz
When Sync is set to Temp+Note or Tempo+Beat: 8/4 – 1/64
Enables or disables LFO sync, and sets how it is
synced when enabled.
Amount of LFO modulation applied.
Speed of modulation.
Length of time the wet signal is offset from the dry
signal.
Amount of modulation applied.
Wet/dry mix of the modulation effect.
Amount of drive applied.
Emulates amount of voltage sent to a tube power-
amp.
Output level of the distorted signal.
Wet/dry mix of the distortion effect.
Dampens or maximizes low end frequencies.
Dampens or maximizes low-mid frequencies.
Dampens or maximizes high-mid frequencies.
Dampens or maximizes high end frequencies.
Value Range
Off, 1st Note, Each Note,
Tempo+Note, Tempo+Beat
0–100%
0.05 – 20.00 Hz
0.0 – 24.0 ms
0–100%
0–100%
0–100%
-100 – 0 – 100%
0–100%
0–100%
-12.0 – 0.0 – +12.0 dB
-20.0 – 0.0 – +20.0 dB
-20.0 – 0.0 – +20.0 dB
-12.0 – 0.0 – +12.0 dB
470