Akai MPC X User Manual page 466

You can also use the DrumSynth:Multi plugin to access
all DrumSynth sounds from one plugin, which includes
additional dedicated effects and mixing controls.
Note: You can only have one DrumSynth:Multi plugin
active per project when in Standalone mode.
DrumSynth 1–8 / Trans/Dist / EQ/Comp
Use the first eight tabs in the Multi to control the same
parameters as the individual DrumSynth plugins. Tap
each tab to cycle between the
Trans/Dist view, and the
Send FX
Use this tab to adjust the settings for the Delay, Diffuser and Reverb effects.
Parameter
Delay Time
Ratio
Feedback
Filter Freq
Reso
Reso Freq
Diffuser Delay
Feedback
Diffusion
Bright
Reverb Mode
Time
Low Cut
High Cut
Drum Sound view, the
EQ/Comp view.
Description
Length of time between the dry signal and the
delayed signal.
Reduces the delay Time in either the Left or
Right stereo field. This is useful for creating
offset, panned delays.
Amount of delay signal fed back into the
delay line.
Sets the center frequency of the filtered delay
signal.
Amount of resonance of the feedback signal.
Center frequency for feedback resonance.
Delay time between the dry signal and the
diffused signal.
Amount of diffused signal sent back into the
delay line.
Rate of increasing density of reverb
reflections.
At lower settings, the sound of individual
reflections is more present.
At higher settings, reflections are more
uniform.
Adjusts the high-end tone of the diffused
signal.
Type of reverb applied.
Length of reverb tail.
Center frequency for the reverb low-pass
filter.
Center frequency for the reverb high-pass
filter.
Value Range
1/32 – 8/4
L 100:50, R 50:100
0–100%
1.00 – 20.0 kHz
0–100%
100 Hz – 10.0 kHz
1/64 – 4/4
0–100%
0–100%
0–100%
Hall, Stadium, Room,
Abstract
0.4 s – +Inf s
1 – 1000 Hz
1.00 – 20.0 kHz
466