Air Instrument Plugins; Air Bassline - Akai MPC X User Manual

AIR Instrument Plugins

MPC now includes three new plugin instruments: AIR TubeSynth, AIR Bassline, and AIR Electric.

AIR Bassline

The AIR Bassline plugin emulates the sound of classic
mono synths, with a contemporary twist. Bassline also
comes packaged with four integrated AIR effects (Chorus,
Delay, Compressor and Hype), as well as two built-in
distortion algorithms (Overdrive and Clip).
Osc/Filter/Envelope
Use this tab to adjust the settings for the oscillators,
as well as their filter and envelope settings.
Parameter
Oscillator Waveform
Sub-Octave Amount of sub-octave oscillator.
Fifth
Start Phase
Glide Time
Boost
Boost Freq.
Boost
Envelope
Filter LP Cutoff
Reso
Filter Env
HP Cutoff
Envelope Amp Attack Length of time for the note to reach full volume.
Amp Decay
Filter Decay Length of time for the filter to reset after being released.
Pitch Mod
Description
Continuously variable waveshape for the oscillator.
Amount of fifth-oscillator.
Position of the waveform when a note is triggered.
Amount of time to slide from the pitch of one note to the next
note played.
Boosts the signal of the oscillator.
Center frequency of the boost.
Amount of effect of the envelope on the Boost section.
Adjust Gain to control the amount of boost.
Adjust Frequency to control the center frequency of the boost.
Cutoff frequency for the low-pass filter.
Resonance of the filter.
Envelope of the filter.
At negative values, decreases the cutoff value based on the
decay value.
At positive values, increases the cutoff value based on the
decay value.
Cutoff frequency for the high-pass filter.
Length of time for the note to reach the sustained volume.
Amount of pitch modulation applied to the envelope.
Value Range
Saw Octave, Saw,
Square, Sine
0–100%
0–100%
Free, 0 degr., 180
degr.
10.0 ms – 2.00 s
0.0 – 48.0 dB
* 1.0 – * 240.0
Gain 0–100%, Off,
Frequency 0–100%
20.0 Hz – 20.0 kHz
0–100%
-100% – 0 – +100%
10.0 – 500 Hz
0–100 Soft,
0–100% Hard
0–100%
0–100%
0–100%
412