Akai MPC X User Manual page 425

Reverb / Compressor / Hype
Use this tab to apply and adjust the settings for the built-in Reverb, Compressor and Hype effects.
Parameter
Reverb Mode
Time
Lo Cut
Hi Cut
Mix
Compressor Threshold
Output
Mix
Ratio
Knee
Attack
Release
Hype High
Low
Description
Type of reverb applied.
Length of reverb tail.
Center frequency for the reverb low-pass filter.
Center frequency for the reverb high-pass filter.
Wet/dry mix of the reverb effect.
Signal level after which the compressor will be
applied.
Amount of additional output gain for the compressed
signal.
Wet/dry mix of the compressor effect.
Amount of compression applied.
How gradually the compressor reacts as the threshold
is reached.
Lower values apply a "soft" knee (compression is
applied more slowly as signal approaches the
threshold), and higher values apply a "hard" knee
(compression is immediately applied when the
threshold is reached).
Length of time to apply the compression.
Length of time for compressed signal to return to
original level.
Dampens or maximizes high end frequencies.
Dampens or maximizes low end frequencies.
Value Range
Hall, Stadium, Room,
Abstract
0.4 s – +Inf s
1 – 1000 Hz
1.0 – 20.0 kHz
0–100%
0.0 – -60. dB
0.0 – +30.0 dB
0–100%
1.0:1 – 100.0:1
0–100%
100 us – 300 ms
10 ms – 4.00 s
-100 – 0 – +100%
-100 – 0 – +100%
425