Akai MPC X User Manual page 475

AIR Mellotron
(continued)
Delay / Spring Reverb
Use this tab to adjust the settings for the delay and spring reverb
effects. Each effect can be turned on and off by using the buttons
on the right side.
Parameter
Delay
Time
L/R Ratio
Feedback
Mix
Reso LP Freq
Reso Bell Freq Center frequency for feedback resonance.
Reso Bell Gain Amount of gain applied to the resonant frequency.
Spring Reverb
Pre-Delay
Time
Low Cut
Diffusion
Width
Mix
Description
Use the button in the upper-right corner to enable or
disable delay.
Amount of time between the dry signal and the
delayed signal.
Reduces the delay Time in either the Left or Right
stereo field. This is useful for creating offset, panned
delays.
Amount of signal fed back into the delay line.
Wet/dry amount of the delay effect.
Low pass frequency for feedback resonance.
Use the button in the upper-right corner to enable or
disable the spring reverb effect.
Length of time between dry signal and reverberated
signal.
Length of reverb tail.
Center frequency for reverb signal low-cut filter.
Rate of increasing density of reverb reflections.
At lower settings, the sound of individual reflections is
more present.
At higher settings, reflections are more uniform.
Stereo width of reverb signal. Higher values give wider
stereo separation.
Wet/dry amount of the reverb effect.
Value Range
Off, On
1/16 – 16/4
50:100 – 100:100 –
100:50
0–100%
0–100%
100 – 16000 Hz
100 – 16000 Hz
0–100%
Off, On
0 – 250 ms
1.00 – 10.00 s
20 – 1000 Hz
0–100%
0–100%
0–100%
475