Akai MPC X User Manual page 417

Trem/Tube/Chorus
Use this tab to apply and adjust the settings for the built-in Tremolo, Tube (Overdrive), and Chorus effects.
Parameter
Tremolo Rate
Sync
Mode
Depth
Tube Drive
Headroom
Saturation
Output
Chorus Rate
Depth
Mix
Delay
Use this tab to apply and adjust the settings for the built-in Delay effect.
Parameter Description
Time Amount of time between the dry signal and the delayed signal.
Sync
Sync the Delay Time to the Global Tempo or set to Free to adjust Time
by milliseconds.
Mix Wet/dry amount of the delay effect.
Feedback Amount of signal fed back into the delay line.
Damp Center frequency of where the delay signal will be dampened.
Reso Amount of resonance of the feedback signal.
Reso Freq Center frequency for feedback resonance.
Ratio Reduces the delay Time in either the Left or Right stereo field. This is
useful for creating offset, panned delays.
HPF Center frequency for delay signal high-pass filter.
Width Stereo width of delay signal. Higher values give wider stereo separation.
Description
Modulation speed of the effect.
Sync the Tremolo Rate to the Global Tempo or let it
run Free.
Select Pan for stereo field modulation, or Tremolo for
amplitude modulation.
Amount of modulation applied.
Amount of drive applied.
Amount of gain reduction between the clean signal
and the driven signal.
Amount of saturation applied.
Output level of the tube driven signal.
Modulation speed of the effect.
Amount of pitch modulation of the effect.
Wet/dry amount of the chorus effect.
When Sync is set to Free: 0.25 – 13.00 Hz
When Sync is set to Sync: 8/4 – 1/16
When Sync is set to Free: 1 ms – 2.00 s
When Sync is set to Sync: 1/32 – 8/4
Value Range
Free, Sync
Pan, Tremolo
0–100%
0–100%
-30.0 – 0.0 dB
0–100%
-20.0 – 0.0 – +20.0 dB
0.40 – 3.20 Hz
0–100%
0–100%
Value Range
Free, Sync
0–100%
0–100%
1.00–20.0 kHz
0–100%
100 Hz – 10.0 kHz
L 50:100, R 50:100
20.0 Hz – 1.0 kHz
0–100%
417