Akai MPC X User Manual page 424

Chorus
Use this tab to apply and adjust the settings for the built-in Chorus effect.
Parameter Description
Rate Modulation speed of the effect.
Delay Length of time the wet signal is offset from the dry signal.
Voices Number of voices used in the chorus effect.
LFO Wave Waveshape of the low-frequency oscillator for the chorus effect.
Depth Amount of pitch modulation of the effect.
Width Stereo width of the chorus effect. Higher values give wider stereo
separation.
Lo Cut Center frequency for the chorus low-cut filter.
Mix Wet/dry amount of the chorus effect.
Delay
Use this tab to apply and adjust the settings for the built-in delay effect.
Parameter Description
Time Length of time between the dry signal and the delayed signal.
Sync Enable to sync the Delay Time to the Global Tempo, disable to set the
Time in milliseconds.
Feedback Amount of delay signal fed back into the delay line.
Mix Wet/dry amount of the delay effect.
Damp Center frequency of where the delayed signal will be dampened.
Reso Amount of resonance of the feedback signal.
Reso Freq Center frequency for feedback resonance.
Ratio
Reduces the delay Time in either the Left or Right stereo field. This is
useful for creating offset, panned delays.
HPF Center frequency for delay signal high-pass filter.
Width Stereo width of delay signal. Higher values give wider stereo separation.
When Sync is set to Free: 1 ms – 2.00 s
When Sync is set to Sync: 1/32 – 8/4
Value Range
0.01 – 10.0 Hz
0.00 – 24.00 ms
3, 4, 6
Tri, Sine
0.00 – 24.00 ms
0–100%
20.0 Hz – 1.0 kHz
0–100%
Value Range
Off, On
0–100%
0–100%
1.00 – 20.0 kHz
0–100%
100 Hz – 10.0 kHz
L 100:50, R 50:100
20.0 Hz – 1.0 kHz
0–100%
424