Submixes - Akai MPC X User Manual

Submixes

The Submixer shows levels, panning, mute states, send and insert effects, and routing for the eight available submixes.
To view a specific setting on all submixes, tap Level, Pan, Mute, Send, Insert, or Route at the bottom of the
screen. You can tap Send or Insert multiple times to cycle through the four available slots for each.
When a submix is selected, you can view and adjust all of its settings in the left side of the screen rather than using
the tab buttons at the bottom.
When viewing the submixer channel strip:
The first field shows the current submix (which you can change).
The second field shows where the submix is routed, which you can change: Out 1,2–31,32 or Out 1–32.
Note: When set to a mono channel, the left and right channels are summed post-pan knob. If the pan knob is set
to the center position, the left and right channels will be summed and padded. If the pan knob is set to the
maximum left or right positions, only the respective channel will be sent to the output.
The Inserts field shows any enabled or disabled effects for that submix. Tap the area under Inserts to open a
window where you can load, change, and enable or disable the effects for all four insert slots.
Tap Mute to mute the submix.
Adjust the pan knob or level slider to change the panning or level of the submix.
302