Akai MPC X User Manual page 423

Setup
Use this tab to adjust plugin setup parameters.
Parameter
Controller Destinations
Velocity 1
Depth
Velocity 2
Depth
Modwheel
Depth
Aftertouch
Depth
Setup Polyphony
Bend Range
Glide Time
Glide All
Detune
Doubling
Output Shape
Width
Level
Description
Send Velocity data to one of the following control
destinations.
Amount of modulation applied.
Send Velocity data to one of the following control
destinations.
Amount of modulation applied.
Send Modwheel data to one of the following
control destinations.
Amount of modulation applied.
Send Aftertouch data to one of the following
control destinations.
Amount of modulation applied.
Number of allowable voices, and how voices are
triggered.
Number of semitones up or down controlled by
MIDI pitch bend messages.
Amount of time to slide from the pitch of one note
to the next note played.
Enables or disables pitch gliding for all triggered
notes, not just legato notes.
Amount of detuning applied. This setting is only
applied when Doubling is enabled.
Enables or disables voice doubling.
Amount of signal sent to a Tube Drive.
Stereo width of the audio signal. Higher values
give wider stereo separation.
Overall output volume of the plugin.
Value Range
Amp, Cutoff, Osc1
Shape, Osc2 Shape,
Osc1&2 Shape
0–100%
Amp, Cutoff, Osc1
Shape, Osc2 Shape,
Osc1&2 Shape
0–100%
Amp, Cutoff, Osc1
Shape, Osc2 Shape,
Osc1&2 Shape
-100 – 0 – 100%
LFO 1 Depth, Cutoff,
Osc1 Shape, Osc2
Shape, Osc1&2 Shape
-100 – 0 – 100%
Legato, Retrigger, 2, 3, 4
0–12 (semitones)
1.00 ms – 100 s
Off, On
0–100%
Off, On
0–100%
0–100%
-Inf dB – +12.0 dB
423