Dell PowerEdge R360 Installation And Service Manual page 63

NOTE: Follow the sequential order as shown in the table to remove the cables, to install the cables follow the reverse
sequential order.
Table 56. Connector descriptions for 4 x 3.5 inch SATA with BOSS N1 (optional)
Order
1
2
3
4
5
6
7
8
9
10
Figure 29. Configuration 1: 4 x 3.5 inch SAS/SATA and fPERC with BOSS N1 (optional)
NOTE: Follow the sequential order as shown in the table to remove the cables, to install the cables follow the reverse
sequential order.
Table 57. Connector descriptions for 4 x 3.5 inch SAS/SATA and fPERC with BOSS N1 (optional)
Order
1
From
SL1_PCH_SA1 (system board signal
connector)
PIB (system board connector)
P1 (system board power connector)
P2 (system board power connector)
SIG_PWR_1(PIB power connector)
CTRL_PNL (system board control panel
connector)
LEFT_LED (system board control panel
connector)
R_INTRUSION (system board intrusion
switch connector)
SL2_PCH_PA2 (system board signal
connector)
MB_BOSS_PWR (System board power
connector)
From
J_SLOT1 (fPERC Riser)
To
BP_DST_SA1 (backplane signal
connector)
PIB_SIG_1 (PIB signal connector)
SYS (PIB power connector)
CPU (PIB power connector)
BP_PWR_1 (backplane power
connector)
Right Ear
Left Ear
Intrusion switch
J_PCIE_1 (BOSS N1 signal connector)
J_PWR_1 (BOSS N1 power connector)
To
CTRL_DST_PA1 (fPERC connector)
Installing and removing system components 63