Removing The Boss N1 Blank - Dell PowerEdge R360 Installation And Service Manual

Figure 60. Installing the BOSS N1 M.2 module
Next steps
1. Install the air shroud.
2. Install the system cover.
3. Follow the procedure listed in

Removing the BOSS N1 blank

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. Remove system cover.
4. Remove air shroud.
Steps
Pull the N1 BOSS blank out of the system to remove it.
90 Installing and removing system components
After working inside your
Safety instructions.
Before working on your system.
system.