Perc Card; Removing The Internal Perc Card; Installing The Internal Perc Card - Dell PowerEdge R360 Installation And Service Manual

PERC card

Your system includes dedicated slots on the system board for PERC cards.

Removing the internal PERC card

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. Remove air shroud.
4. Remove the expansion card riser
Steps
1. Loosen and remove the two screws securing the PERC card.
2. Hold the metal holder, slide the PERC card towards the PSU to remove it from the system.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 65. Removing the internal PERC card
Next steps
1. Install the adapter PERC.

Installing the internal PERC card

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. Remove air shroud.
4. Remove the expansion card riser
94 Installing and removing system components
Safety instructions.
Before working on your system.
(if installed).
Safety instructions.
Before working on your system.
(if installed).