Dell PowerEdge R360 Installation And Service Manual page 64

Table 57. Connector descriptions for 4 x 3.5 inch SAS/SATA and fPERC with BOSS N1
(optional) (continued)
Order
2
3
4
5
6
7
Figure 30. Configuration 2: 4 x 3.5 inch SAS/SATA and internal PERC card
NOTE: Follow the sequential order as shown in the table to remove the cables, to install the cables follow the reverse
sequential order.
Table 58. Connector descriptions for 4 x 3.5 inch SAS/SATA and internal PERC card
Order
1
2
3
4
5
64 Installing and removing system components
From
PIB (system board connector)
P1 (system board power connector)
P2 (system board power connector)
SIG_PWR_1(PIB power connector)
SL2_PCH_PA2 (system board signal
connector)
MB_BOSS_PWR (System board power
connector)
From
CTRL_SRC_SA1 (adapter PERC
controller connector)
PIB (system board connector)
P1 (system board power connector)
P2 (system board power connector)
SIG_PWR_1(PIB power connector)
To
PIB_SIG_1 (PIB signal connector)
SYS (PIB power connector)
CPU (PIB power connector)
BP_PWR_1 (backplane power
connector)
J_PCIE_1 (BOSS N1 signal connector)
J_PWR_1 (BOSS N1 power connector)
To
BP_DST_SA1 (backplane signal
connector)
PIB_SIG_1 (PIB signal connector)
SYS (PIB power connector)
CPU (PIB power connector)
BP_PWR_1 (backplane power
connector)