Lenovo 7X69 Manual page 55

User Action:
Information only; no action is required
• FQXSPFW2001I: The System [ComputerSystemElementName] has detected a POST Error
deassertion.
This message is for the use case when an implementation has detected that Post Error has deasserted.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: Critical - Other
SNMP Trap ID: 50
CIM Prefix: PLAT CIM ID: 0185
User Action:
Information only; no action is required.
• FQXSPIO0000I: The connector [PhysicalConnectorElementName] has been detected as present or
connected.
This message is for the use case when an implementation has detected a Connector has been
Connected.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID: 60
CIM Prefix: PLAT CIM ID: 0264
User Action:
Information only; no action is required
• FQXSPIO0001L: The connector [PhysicalConnectorElementName] has encountered a
configuration error.
This message is for the use case when an implementation has detected an Interconnect Configuration
Error.
Severity: Error
Serviceable: Yes
Automatically notify Support: Yes
Alert Category: Critical - Other
SNMP Trap ID: 50
CIM Prefix: PLAT CIM ID: 0266
User Action:
Complete the following steps until the problem is solved:
1. Make sure that the cable from the light path LED card to the system board is securely connected.
2. Replace the front operator panel.
• FQXSPIO0003N: A diagnostic interrupt has occurred on system [ComputerSystemElementName].
This message is for the use case when an implementation has detected a Front Panel NMI / Diagnostic
Interrupt.
Severity: Error
.
Chapter 2 XClarity Controller events
51