Lenovo 7X69 Manual page 10

Table 2. Events organized by severity (continued)
Message String
Event ID
FQXSPBR400CI Management Controller [arg1]: cloning configuration from neighbor
server [arg2] by group name [arg3] failed to start.
FQXSPBR400DI Neighbor group clone configuration was initiated by user [arg1].
FQXSPBR400EI Neighbor group firmware update was initiated by user [arg1].
FQXSPBR400FI The neighbor group management is [arg1] by user [arg2] from [arg3] at
IP address [arg4].
FQXSPBT0007I No bootable media available for system
[ComputerSystemElementName].
FQXSPCA0013I Sensor [SensorElementName] has transitioned to normal state.
FQXSPCA2002I Numeric sensor [NumericSensorElementName] going low (lower
critical) has deasserted.
FQXSPCA2007I Numeric sensor [NumericSensorElementName] going high (upper
non-critical) has deasserted.
FQXSPCA2009I Numeric sensor [NumericSensorElementName] going high (upper
critical) has deasserted.
FQXSPCA2011I Numeric sensor [NumericSensorElementName] going high (upper
non-recoverable) has deasserted.
FQXSPCA2015I Sensor [SensorElementName] has deasserted the transition from
normal to non-critical state.
FQXSPCA2017I Sensor [SensorElementName] has transitioned to a less severe state
from critical.
FQXSPCA2019I Sensor [SensorElementName] has deasserted the transition to non-
recoverable from a less severe state.
FQXSPCN4000I Serial Redirection set by user [arg1]: Mode=[arg2], BaudRate=[arg3],
StopBits=[arg4], Parity=[arg5], SessionTerminateSequence=[arg6].
FQXSPCN4001I Remote Control session started by user [arg1] in [arg2] mode.
FQXSPCN4002I User [arg1] has terminated an active CLI console session.
FQXSPCN4003I Remote Control session started by user [arg1] in [arg2] mode has
been closed.
FQXSPCN4004I User [arg1] has created an active [arg2] console session.
FQXSPCN4005I A [arg1] console session is timeout.
FQXSPCN4006I User [arg1] has terminated an active IPMI console session.
FQXSPDM4000I Inventory data changed for device [arg1], new device data hash=
[arg2], new master data hash=[arg3] .
FQXSPDM4001I Storage [arg1] has changed.
FQXSPDM4003I TKLM servers set by user [arg1]: TKLMServer1=[arg2] Port=[arg3],
TKLMServer2=[arg4] Port=[arg5], TKLMServer3=[arg6] Port=[arg7],
TKLMServer4=[arg8] Port=[arg9].
FQXSPDM4004I TKLM servers device group set by user [arg1]:
TKLMServerDeviceGroup=[arg2] .
6
ThinkSystem SR860 Messages and Codes Reference
Severity
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational