Table of Contents
Advertisement
This message is for the use case when an implementation has detected that the Sensor transition to non-
recoverable from less severe has deasserted.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: Critical - Other
SNMP Trap ID: 50
CIM Prefix: PLAT CIM ID: 0525
User Action:
Complete the following steps until the problem is solved:
1. Flash uEFI to the latest level.
2. Remove CMOS batter and re-install again to clear the data.
3. If the problem still exist, please contact local service support
• FQXSPUN2023I: Sensor [SensorElementName] has deasserted the transition to non-recoverable.
This message is for the use case when an implementation has detected that the Sensor transition to non-
recoverable has deasserted.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: Critical - Other
SNMP Trap ID: 50
CIM Prefix: PLAT CIM ID: 0531
User Action:
Information only; no action is required.
• FQXSPUN2030I: Device [LogicalDeviceElementName] has been removed from unit
[PhysicalPackageElementName].
This message is for the use case when an implementation has detected a Device was removed.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID:
CIM Prefix: PLAT CIM ID: 0537
User Action:
Information only; no action is required.
• FQXSPUP0005L: A firmware or software incompatibility was detected on system
[ComputerSystemElementName].
This message is for the use case when an implementation has detected a Firmware or Software
Incompatibility.
Severity: Error
Serviceable: Yes
Automatically notify Support: No
Alert Category: Critical - Hardware Incompatibility
SNMP Trap ID: 36
.
Chapter 2
XClarity Controller events
137
Advertisement
Table of Contents
