Lenovo 7X69 Manual page 193

User Action:
Complete the following steps:
1. Re-install the original TCM/TPM card that shipped with the system.
2. Reboot the system.
3. If the problem persists, collect Service Data logs and contact Lenovo Support.
Note: The solution for this error may involve a system board replacement. If TPM encryption has
been enabled, back up TPM Encryption Recovery Key.
• FQXSFPU4080I: Host Power-On password has been changed.
Severity: Info
User Action:
Information only; no action is required.
• FQXSFPU4081I: Host Power-On password has been cleared.
Severity: Info
User Action:
Information only; no action is required.
• FQXSFPU4082I: Host Admin password has been changed.
Severity: Info
User Action:
Information only; no action is required.
• FQXSFPU4083I: Host Admin password has been cleared.
Severity: Info
User Action:
Information only; no action is required.
• FQXSFPU4084I: Host boot order has been changed.
Severity: Info
User Action:
Information only; no action is required.
• FQXSFPU4085I: Host WOL boot order has been changed.
Severity: Info
User Action:
Information only; no action is required.
• FQXSFPW0001L: CMOS has been cleared.
Severity: Warning
User Action:
Complete the following steps:
1. If the CMOS clear was user initiated this event can be safely ignored and no further action is required.
2. If the system was recently installed, moved, or serviced, make sure the battery is properly seated.
. 189
Chapter 3 UEFI events