Section 10 − Maintenance And Troubleshooting; Routine Maintenance; Blowing Out Inside Of Unit - Miller Maxstar 400 Owner's Manual

SECTION 10 − MAINTENANCE AND TROUBLESHOOTING

10-1. Routine Maintenance

n = Check
* To be done by Factory Authorized Service Agent
Every
3
Months
nl Labels
Every
3
Months
nΔ lCables And Cords
Every
6
Months
~:Durning heavy service, clean monthly.

10-2. Blowing Out Inside of Unit

OM-275857 Page 62
.
A complete Parts List is available at www.MillerWelds.com
! Disconnect power before maintaining.
Z = Change ~ = Clean
n l Gas Hoses
Δ = Repair l = Replace
~ Weld Terminals
!
To blow out unit, direct airflow
through front and back louvers as
shown.
Do not remove case when
blowing out inside of unit.
804746-B