Controls - Miller Maxstar 400 Owner's Manual

SECTION 7 − MAXSTAR OPERATION
7-1.

Controls

4
12
11
.
For all front panel switch pad controls:
press switch pad to turn on light and en-
able normal function.
.
Green on nameplate indicates a TIG
function, Gray indicates a normal Stick
function.
1 Encoder Control
Use Encoder control in conjunction with ap-
plicable front panel function switch pads to
change values for that function.
2 Memory Card Port And Indicator
OM-275857 Page 44
.
A complete Parts List is available at www.MillerWelds.com
5 6 7
Port is used to add features to the machine,
and update software. Indicator is lit while
card is being accessed.
3 Ammeter And Parameter
Shows actual amperage while welding and
preset amperage while idle. It also shows
parameter selection options when in any
menu.
4 Voltmeter And Selected Parameter
Display
Shows actual rectified average voltage
when voltage is present at the weld output
2 3
8 9
terminals. It also show parameter descrip-
tions when in any menu.
5 Process Controls
Display
6 Output Controls
7 Pulser Controls
8 Sequencer Controls
9 Gas/DIG Controls
10 Amperage And Spot Time Control
11 Memory
12 Memory Display
Displays active memory.
1
10
275861-B / Ref. 803901-A