Miller Maxstar 400 Owner's Manual page 19

Do not discard product (where applicable) with general waste.
Reuse or recycle Waste Electrical and Electronic Equipment (WEEE) by disposing at a designated collection
facility.
Contact your local recycling office or your local distributor for further information.
Environmental Protection Use Period (China)
Disconnect input plug or power before working on machine.
When power is applied failed parts can explode or cause other parts to explode.
Always wear long sleeves and button your collar when servicing unit.
After taking proper precautions as shown, connect power to unit.
Do not use one handle to lift or support unit.
= < 60°
V
>60s
OM-275857 Page 10
.
A complete Parts List is available at www.MillerWelds.com
V
V
Always lift and support unit using both handles. Keep angle of lifting
device less than 60 degrees.
Use a proper cart to move unit.
Hazardous voltage remains on input capacitors after power is turned
off. Do not touch fully charged capacitors. Always wait 60 seconds
after power is turned off before working on unit, OR check input ca-
pacitor voltage, and be sure it is near 0 before touching any parts.
Become trained and read the instructions before working on the
machine or welding.
Wear hat and safety glasses. Use ear protection and button shirt
collar. Use welding helmet with correct shade of filter. Wear complete
body protection.
Safe37 2012−05
Safe123 2016−06
Safe30 2012−05
Safe26 2012−05
Safe28 2012−05
Safe29 2012−05
Safe31 2012−05
Safe44 2012−05
Safe42 2012−05
Safe40 2012−05
Safe38 2012−05