Accessing Control Panel Menu - Miller Maxstar 400 Owner's Manual

6-2.

Accessing Control Panel Menu

2
1
OM-275857 Page 40
.
A complete Parts List is available at www.MillerWelds.com
3
4
Polarity Selection (Dynasty Only)
Select output type AC or DC. With DC selected, the electrode will be negative (DCEN) for TIG, and
positive (DCEP) for Stick.
Process Selection
TIG HF Impulse is a non-contact arc starting method for AC and DC TIG welding (see Section 15-1).
TIG Lift-Arc Is a contact arc starting method for AC and DC TIG welding (see Section 15-1).
Stick − Select AC or DC Stick (SMAW) welding.
Trigger Mode Selection (See Section 9-3 for additional trigger function options).
[RMT] [STD]
Typical setting for a remote foot or hand control. RMT STD requires a maintained contact closure to
enable weld output. Amperage can be controlled with a remote potentiometer, or it can be set at the
control panel.
[RMT] 2T [HOLD] (TIG Only)
Remote control required. Allows the operator to weld without holding the trigger closed. To start the
weld, operator presses and releases trigger. To stop the weld, the operator again presses and re-
leases the trigger. In this mode, only the output contactor is controlled by the remote control. Amper-
age must be set on the control panel. (see Section 9-3).
[OUT] [ON]
Output on. (Stick and TIG Lift Only)
! Weld output terminals are energized at all times when displays read [OUT] [ON].
No remote control or trigger required. Amperage can be controlled at the control panel or with a remote
potentiometer . Blue output on LED illuminates to indicate output is on.
1 Memory Button
Select Memory 1-9 (See Section 14)
2 Parameter Display
3 Setting Display
4 Encoder Control
Rotate Encoder to adjust parameter
5
setting.
5 Amperage Button
Amperage Control
Controls the welding amperage output.
Limits the maximum output of a remote
amperage device.
273670-B