Eizo CuratOR LX490W Instructions For Use Manual page 36

Operation
7.7 "Image" menu
Function
Image size / zoom
Sharpness filter
Sharpness mode
H-position
V-position
Phase
Frequency
36
Values
One to One
Fill to aspect ratio
Fill screen
Default setting: One to
One
Slider control
Enhanced
Normal
Default setting: Enhanced
Slider control
Slider control
Slider control
Slider control
Description
Selection between different picture size
settings:
• One to One: The picture is displayed on
screen in its original resolution.
Fill to aspect ratio: The picture is zoomed
•
to the maximum screen area with reten-
tion of the aspect ratio.
• Fill screen: The picture is displayed to fill
the complete screen (1920 x 1080 pixels).
Select the sharpness setting
Note: To display the "Sharpness filter" func-
tion, "Sharpness mode" must be set to "Nor-
mal".
Use the sharpness setting to reduce scaling
artifacts or make the image "softer". A lower
value creates a "soft" image impression and a
higher value a "sharp" one.
Note: The optimum sharpness setting has to
be determined visually.
Common filters are available for the RGB
sources (VGA, DVI).
The interpolation filters depend on the input
resolution. At lower resolutions, the filter cal-
culates the value for the non-controlled pix-
els.
Setting image sharpness mode
Select "Enhanced" to display the image with
the sharpest setting.
Under "Normal", image sharpness can be set
using the "Image sharpness filter" slider con-
trol.
Shift picture in horizontal direction
Shift picture in vertical direction
Set the frequency and phase of the input
signal
Correct potential blur in the vertical lines by
adjusting the "Frequency/Phase" setting.
Note: Use a vertical line in a "Pixel On/Off"
test pattern to make the adjustment.
Instructions for Use, 06/2017
CuratOR LX490W