Table of Contents
Advertisement
Operation
7.11 "Utilities" menu
Function
Power save / DPMS
DPMS
Backlight
Communication
Communications inter-
face
Source selection se-
quence
Reset operations
44
Values
Enabled / Disabled
Default: Enabled
Dimmed
Off
Default: Off
DDC / DVI digital
USB
Default: USB
Reset to firmware de-
faults...
Description
Switching on or off the DPMS (Display
Power Management System)
Note: "Enabled" and "Disabled" modes of the
DPMS standard are supported for analog sig-
nals. For digital signals, DVI-DMPM is sup-
ported at the DVI/HDMI connection sockets
•
If "DPMS" is activated and there is no in-
put signal, the backlight is switched off or
dimmed.
This saves power and increases the ser-
vice life of the backlight.
The "Backlight" can be set to "Dimmed"
or "Off"
When the DPMS mode is active, the back-
light is either dimmed or switched off. The
controller board and power supply unit re-
main active. For digital signals , 5 V is also
applied to the DVI socket for external mod-
ules.
Select the interface for communication
Serial communication is always active.
Installers can also select between USB and
DDC.
The source scan is interrupted as soon as the
first source with an active video signal is
found. This signal is then displayed.
All user settings are deleted and reset to the
firmware defaults.
Instructions for Use, 06/2017
CuratOR LX490W
Advertisement
Table of Contents
