Figure 48. Installing the network daughter card
Next steps
1. Install the
expansion card riser 2
2. Follow the procedure listed in
Integrated storage controller card
Your system includes a dedicated expansion card slot on the system board for the primary storage controller card. The storage
controller card provides the storage subsystem for internal hard drives of your system. The controller supports SAS and SATA
hard drives.
Removing the integrated storage controller card
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. Remove the
air
shroud.
4. Remove the
expansion card riser
Steps
1. Using Phillips #2 screwdriver, loosen the screws that secure the integrated storage controller cable to the connector on the
system board.
2. Lift the integrated storage controller cable to disconnect it from the connector on the system board.
90
Installing and removing system components
or the rear hard drive cage, depending on the configuration of your system.
After working inside your system
Safety instructions
Before working inside your system
1.
on page 56.
on page 55.
on page 56.