Table of Contents
Advertisement
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that are shipped with your product.
Steps
1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and
peripherals.
NOTE:
It is recommended that you always use a static mat and static strap while working on components inside system.
2. Open the system cover.
3. Locate the BOSS card on the system board.
CAUTION:
To prevent damage to the card, you must hold the card by its edges only.
4. After ensuring that the PCIe bracket is unobstructed, lift the card to remove it from the connector on the system board.
Figure 87. Removing the BOSS card
a. BOSS-S1 card
b. card connector on the system board
Removing the M.2 SSD module
About this task
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell EMC is not covered
by your warranty. Read and follow the safety instructions that are shipped with your product.
Steps
1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and
peripherals.
NOTE:
It is recommended that you always use a static mat and static strap while working on components inside the
system.
2. Open the system cover.
3. Remove the card. See
4. Loosen the screws and lift the retention straps that secure the M.2 SSD module on the BOSS card.
130
BOSS card
Removing the BOSS
card.
Advertisement
Table of Contents
