Table of Contents
Advertisement
NOTE:
To use an SD card with your system, ensure that the Internal SD Card Port is enabled in System Setup.
NOTE:
Re-install the micro SD cards into the same slots based on the labels you had marked on the cards during removal.
Steps
1. Locate the SD card connector on the internal dual SD module. Orient the SD card appropriately and insert the contact-pin
end of the card into the slot.
NOTE:
The slot is keyed to ensure correct insertion of the card.
2. Press the card into the card slot to lock it into place.
Next steps
Follow the procedure listed in
Removing the IDSDM/vFlash card
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. If you are replacing the IDSDM/vFlash card, remove the
NOTE:
Temporarily label each micro SD card with its corresponding slot number after removal.
Steps
1. Locate the IDSDM/vFlash connector on the system board.
To locate IDSDM/vFlash, see
2. Holding the pull tab, lift the IDSDM/vFlash card out of the system.
Figure 45. Removing the optional IDSDM/vFlash card
After working inside your system
Safety instructions
Before working inside your system
System board jumpers and connectors
on page 56.
on page 55.
on page 56.
micro SD
card.
on page 123.
Installing and removing system components
87
Advertisement
Table of Contents
