Figure 79. Installing the cable cover
Next steps
1. Install the
air
shroud.
2. If applicable, install the
3. Follow the procedure listed in
Removing the right control panel
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
NOTE:
Ensure that you note the routing of the cables as you remove them from the system board. You must route the
cables properly when you replace them to prevent the cables from being pinched or crimped.
3. For ease of removal of the right control panel, remove the
Steps
1. Pull the cable latch and disconnect the control panel cable from the system board connector.
2. Using Phillips #1 screwdriver, remove the screws that secure the cable cover.
Figure 80. Removing the cable cover
3. Using Phillips #1 screwdriver, remove the screws that connect the control panel to the system.
Figure 81. Removing right control panel
cooling fan
#1.
After working inside your system
Safety instructions
Before working inside your system
on page 56.
on page 55.
on page 56.
cooling fan
#8 to access the cable latch.
Installing and removing system components
117